Bedienungsanleitung - Selecting the speed source

Selecting the speed source

Supported speed sources:

▪: "Sensor" – Sensors that are installed on the field sprayer and connected to the job computer:

–: Examples: Wheel sensor, radar sensor, impulse-transmitting GPS speed sensor

–: Configuration: Configure the number of impulses per 100 meters.

▪: "ISOBUS" – Sensors that are installed on the tractor and whose signal is received through the ISOBUS.

–: Examples: GPS receiver, wheel sensor on the tractor, signal socket

–: Configuration: For systems without the option of selecting the sensor input, the "impulses per 100 metres" parameter must be set to 0.

▪: "Auto" – As of software V7.5, some systems enable automatic detection of the speed source.

–: Mode of operation: If a speed signal is detected on the ISOBUS, this speed will be used as a basis. In the case of signal failure, the job computer will take the impulses from the sensor connected to the job computer as a basis for determining the speed.

–: Configuration: For systems that have two sensor types, it is recommended to calibrate the sensor that is connected to the job computer. In other cases, set the "Impulses per 100 meters" parameter to 0.

Procedure 1

To configure the speed source:

1.: On the work screen, press the following keys successively:
>

⇨: The "Speed" screen appears.

2.: Configure the "Speed source" parameter.

Procedure 2

If the "Speed source" parameter does not appear on the "Speed" screen, and the speed signal should be received through the ISOBUS, proceed as follows:

þ: The speed signal can be received through the ISOBUS.

1.: Switch to the "Parameters" screen:

2.: Set the "Wheel pulses" parameter to "0".