Configuring the SMART-6L
Procedure
- þ
- The GPS receiver is connected to the terminal.
- þ
- The GPS receiver is connected directly to the terminal. Additional devices such as an external lightbar or tilt module may not be connected in between.
- þ
- The “AG-STAR, SMART-6L” driver is activated.
- Open the “Service” application.- 2.
- Tap “GPS”.
- ⇨
- The “Settings” screen appears.
- ⇨
- The following message appears during initial configuration: “GPS receiver detected. Read the configuration?”
- 3.
- To confirm, tap “Yes”. To cancel, tap “No”.
- ⇨
- The terminal reads the current configuration of the GPS receiver.
- ⇨
- You can now see all of the configurable parameters.
- 4.
- Configure the parameters. The parameters can be found on the following pages.
- 5.
- Reconnect all of the additional devices that you had disconnected for the configuration.
Further information