Configuring the joystick button allocations
The terminal offers you the possibility of assigning the functions of an ISOBUS job computer to the buttons of the joystick. To do so, the ISOBUS job computer and the joystick must fulfil the Auxiliary 2 specification requirements from the ISOBUS standard.
Procedure
To activate the driver for this function:
- þ
- The joystick and ISOBUS job computer are connected and both support the Auxiliary 2 protocol.
- Open the “Service” application.- 2.
- Tap "Driver".
- 3.
- Tap “Auxiliary”.
- 4.
- Mark “Auxiliary2”.
- 6.
- Restart the terminal.
Procedure
To configure the button assignment:
- þ
- You have activated the “Auxiliary2” driver
- 2.
- Tap “Auxiliary”.
- 3.
- Tap “Auxiliary Editor”.
- ⇨
- If the ISOBUS job computer supports the Auxiliary 2 protocol, a list appears of the job computer functions.
- ⇨
- If no list appears, the ISOBUS job computer does not support this protocol.
- 4.
- Tap the function which you want to assign to this button on the joystick.
- ⇨
- A list of the buttons on the joystick appears.
- ⇨
- You have two options for assigning the function to the joystick.
- 5.
- Option 1: On the joystick, press the button to which you want to assign the function.
Option 2: On the terminal, select the button to which the selected function should be assigned and confirm with
.
- ⇨
- The function will be assigned to the button and you can continue with the next function, until you have assigned all of the functions.
- 6.
- Restart the terminal.
- ⇨
- After restarting, the following notification appears on the main terminal screen: “Confirm the assignments.” This notification appears after any restart.
- 7.
- “OK” - acknowledge the notification.
- ⇨
- A list of recognized assignments appears on the terminal screen.