Configuring the “GPS TILT-Module” tilt module
You can use an A100, A101, AG-STAR or SMART-6L with the “GPS TILT Module” tilt module. In this case, you have to configure the module.
Procedure
- þ
- The “GPS TILT-Module” tilt module is connected.
- þ
- The tractor is positioned on level ground.
- þ
- The lightbar driver is configured as a “screen lightbar”.
- 1.
- If additional devices (e.g. external lightbar) are connected to the cable between the terminal and the tilt module, disconnect them. The tilt module must be connected directly to the terminal. After the tilt module has been configured, these additional devices must be reconnected.
- 2.
- Measure the distance between the GPS receiver and the ground on which the tractor is positioned.
- 3.
- Switch on the terminal.
- Open the “Service” application.- 5.
- Tap “GPS”.
- ⇨
- The “Settings” screen appears.
- 6.
- Scroll down until the “Tilt module” parameter appears on the screen.
- 7.
- Tap “Tilt module”.
- 8.
- Enter the measured distance on the “GPS receiver height” line.
.- ⇨
- Message: “Tilt module will be configured.” is displayed.
- 10.
- To confirm, tap “Yes”.
- ⇨
- The position of the tilt module on level ground is being calibrated.
- ⇨
- After calibration, the angle 0 will appear on the “Angle” line. The displayed angle will change with any tilt of the tractor.
- 11.
- Reconnect all of the additional devices that you had disconnected for the configuration.