Company logo
Operating InstructionsSearchTable of contentsHome
 
Parallel guidance TRACK-LeaderMarking obstacles
 
 
Marking obstacles
 
When there are obstacles in your field, you can mark their position. In this way, you will always receive a warning before any collision can occur.
You can mark obstacles while working in a field.
You will be warned of an obstacle in the following cases:
▪
If the obstacle will be reached in 20 seconds or earlier.
▪
If the distance between the obstacle and the vehicle is smaller than the working width of the agricultural device.
The warning always consists of two elements:
▪
A graphical warning in the upper left-hand corner of the work screen
–
“Field boundary”
–
“Obstacle”
▪
Acoustic signal
 
 
CAUTION
Obstacles
The software can warn you about obstacles. It cannot brake nor avoid the obstacles.
 
 
Function icon
Meaning
Calls up additional function symbols.
Creates a new obstacle.
Deletes all obstacles.
Deletes the selected obstacle.
Moves the obstacle.
Saves the obstacle.
 
 
 
Procedure
 
 
 
þ
You have started a navigation.
1.
 TL_Hindernis_Einstellung - Call up new function icons.
2.
 TL_Hindernis_erzeugen - Add an obstacle.
⇨
The keyboard appears.
3.
Give a name to the obstacle.
4.
 Acknowledge_color - Confirm.
⇨
A flashing red point appears on the terminal screen. This marks the point at which the obstacle can be found. The distance between the obstacle and the GPS receiver will then be displayed.
5.
Use the arrow to move the point so that the distances on the terminal screen correspond to those on the field.
6.
 TL_Hindernis_bestaetigen - Save the position of the obstacles in the field.
⇨
The obstacle now appears on the work screen.
 
Further information
•
Deleting obstacle markers