Configuring automatisms when driving in reverse
Several tractors can send a signal through the ISOBUS to all ISOBUS job computers when the reverse gear is engaged. TRAIL-Control can then detect a reverse driving signal and react to it.
As a standard, TRAIL-Control stops working if a reverse driving signal is detected. In this case, the automatic mode remains activated, but the hydraulic valves are not being controlled.
You can configure how TRAIL-Control should react when a reverse driving signal is received.
Procedure
To activate the automatisms:
> 
- ⇨
- The "TRAIL-Control" screen will appear.
- Press.- ⇨
- The second page of "TRAIL-Control" appears.
- ⇨
- An automatism is described on each line. On the left in the brackets, you can see the conditions under which a mechanism is executed. On the right, the effects.
- 3.
- To activate functions, set the check mark on the desired line. These functions will be explained in the following sections.
Further information