Bedienungsanleitung - Configuring the reverse driving sensor

Configuring the reverse driving sensor

If the trailed implement or the tractor sends a reverse driving signal through the ISOBUS, the job computer can use this signal to adjust its regulating behaviour when driving in reverse.

You can find more information in this section: Configuring automatisms when driving in reverse

Signal sources

The following signal sources are possible:

▪: "None" - The job computer should not expect a reverse driving signal. Even if a reverse driving signal is transmitted through the ISOBUS, the job computer will ignore the signal.

▪: "ISOBUS" - The reverse driving signal is sent by the tractor or a different job computer through the ISOBUS.

▪: "Sensor" - A reverse driving sensor is connected to the junction box or cable harness of the job computer.

Procedure

To select the reverse signal source:

1.: Switch to the "SPEED" screen:
>

2.: Select the box below the "Reverse drive sensor" parameter.

⇨: The available signal sources appear. See the description at the beginning of this section.

3.: Select the signal source.

4.: Restart the job computer.