Configuring the job computer
Vario and Select mode - configuring multiple nozzle holdersConfiguring the nozzles on the multiple nozzle holderCalibrate the nozzles
Vario and Select mode - configuring multiple nozzle holdersConfiguring the nozzles on the multiple nozzle holderCalibrate the nozzlesCalibrate the nozzles
If you install a non-ISO-compliant nozzle, or if you notice that your nozzles perform differently than stipulated under ISO norms, you can re-calibrate the nozzles.
Procedure
- þ
- You have selected the nozzle to be calibrated.
- Call up the nozzle configuration- 2.
- Enter the nozzle parameter. You can read these parameters either in the documentation from the nozzle manufacturer, or determine them yourself.
The calibration procedure is similar to systems without multiple nozzle holders. See section: Calibrate the nozzles