Bedienungsanleitung - Starting in TRACK-Leader – Without ISOBUS-TC

Operating Instructions

Table of contents

Starting in TRACK-Leader – Without ISOBUS-TC

Procedure

þ: If you are working with an ISOBUS job computer, it has to be connected to the ISOBUS.

þ: If you want to work without an ISOBUS job computer, you must activate the virtual job computer in the Virtual ECU application. You can find more information on this in the instructions of the terminal.

þ: You have set the “Operating Mode” parameter to “Standard” in the ISOBUS-TC application.

1.: - Open the TRACK-Leader application.

⇨: The following screen appears:

⇨: If the text “...” appears instead of “Navigation”, you have not fulfilled one of the preconditions. To find out the precise cause, tap :

2.: Tap “Storage”.

⇨: The “Storage” screen appears:

3.: You must now decide whether you want to work on a field for the first time, or if you want to work on a field whose field boundaries you have already saved. Decide which of the following options you want to use and continue to read at Step 8.

4.: Option a: If you want to process a new field, you must ensure that there is no previous recording in the storage. Tap to discard the opened recording. (The recording will not be deleted from the SD card.)

⇨: No field is displayed on the screen.

5.: Option b: If you want to work on a field with field data you already have on the SD card, tap to load the field data from the SD card.

⇨: The field that you have loaded appears on the screen.

⇨: You have two options with the loaded field:

6.: Option b1: You want to continue working on this field.
If you want to continue working on this field, but you want to use a different implement to do so, you first have to connect the other implement.
Continue reading starting at Step 8.

7.: Option b2: You want to perform a new task on this field, and only need the field boundary. Tap to delete the tracks.

8.: - Exit the “Storage” screen.

⇨: The application start screen appears.

9.: - Start a new navigation.

⇨: The work screen appears. It will only contain the icon for the vehicle or also loaded field boundaries and applied areas - depending on which data was previously loaded.

⇨: If the icon appears at the centre of the terminal screen, there is no connection to the GPS receiver, and you will not be able to continue work. Install and configure a GPS receiver.

10.: To find out more about the information appearing on the work screen, read this section: Information on the work screen

11.: To find out what you should do next, read this section: Operating procedures