Calibrating TRAIL-Control
or 
function key as soon as someone approaches the trailed implement.When should you calibrate?
- ▪
- Prior to initial start-up.
- ▪
- At the start of each season.
- ▪
- When inaccuracies occur.
Sequence
There are two steps involved in calibrating TRAIL-Control:
- ▪
- Step 1: Teach-in the middle position and end stops and calibrate the slope sensor.
- In this step you teach the job computer the position of the drawbar and/or the axle in the middle, left and right positions.
- The job computer calculates all intermediate positions itself.
- To do so, the slope sensor must be installed. Its position may no longer be changed after this.
- ▪
- Step 2: Calibrating the hydraulics of the proportional valve
- Only for trailed implements with proportional valves
- In this step, the trailed implement is automatically steered to both sides and the voltages are measured.
- The calibration runs automatically.
Further information