Calibrating Delay on start and Delay on stop
This section is intended for advanced users.
Before reading the section:
- ▪
- Learn how to operate the terminal.
- ▪
- Learn how to operate the SECTION-Control.
The standard values of parameters “Implement delay on start” and “Implement delay on stop” are set for work with most implements.
When should you calibrate?
These parameters must be calibrated in the following cases:
- ▪
- If you are using an implement with SECTION-Control.
- ▪
- If the agricultural device switches too late or too early when driving on an area where the product has been already applied.
- ▪
- If the agricultural device switches too late or too early when leaving an area already where the product has been already applied.
In the sections below you will learn how to calibrate the parameters.
The sections and examples are given for sprayers. For different agricultural devices, please proceed accordingly.
Calibration phases
Calibration consists of several phases:
- 1.
- Calibration preparations
- 2.
- Travelling the field for the first time
- 3.
- Travelling the field for the second time
- 4.
- Marking the application boundaries.
- 5.
- Calculating correction values
- 6.
- Correcting the “Delay correction on start” and “Delay correction on stop” parameters
The phases are explained in detail in the following sections.
Further information